Overview:Aiming at the problems exist on the open sourced controller board such as Ramps 1.4, the developers in Makerbase specially optimize and develop a new product, MKS-Gen L, which provides more flexible choices for users.Features:Stable and reliable filter circuit greatly reduces interference and avoids crashes as possible in the process of printing.Use CH340 serial port chip, more easily install the drive than 16U2.Run Marlin firmware, the configuration is completely same as Ramps 1.4, and available to directly replace the Ramps 1.4.Support Ramps 1.4, 2004LCD,12864LCD, TFT28 and TFT32.Available to input 24V, the heated bed current can be reduced to 1/4 at the same system power which effectively resolves the problem that the MOSFET of heated bed heats.X axis, Y axis and Z axis with different color terminal controls the stepper motors and endstops, which is convenient to wire.Plug the stepper drivers according to the different color terminals which decreases the probability of reverse and prevents the controller board damage.TMC2208TMC2208 single-axis stepper motor drive chip, power tube built-in drive current 1.4A peak current 2A, voltage range 4.75V-36V, 256 subdivision;Flexible microPlyer interpolation unit, the component can provide up to 256 microstep / step resolution, even in the pulse rate is limited system can still be perfect to achieve sinusoidal control; Both components have pulse / direction input, can be completely independent operation. The configuration is implemented via digital input.Package Included:1x MKS-Gen L V1.0 board1x 50cm USB cable5x TMC2208 V1.0 Stepper Motor Driver5x Heatsink1x ScrewdriverOur own quality m